<< Back

MS1-Extra

General Settings LED17 (D14)
Spark Output Inverted = No

Only for use with the MS1 Extra code (MS1 - 68H908 based microprocessors)

By Philip Ringwood (daxtojeiro), James Murrey (jsmcortina) and Ken Calver (muythaibxr)

Please Note:

All of these instructions / diagrams are to be used at your own risk, like most things there is more than one way to do the same thing, what we have tried to do is to offer a method that we have tested or that others have tested for us. No warranty expressed or implied.

Use at your own risk.

If using a distributor based setup and Spark then set Distributor to MSnS. In this case the Spark Output Inverted is set to No. This applies when the signal is taken off the LED (transistor collector) and then drives a VB921. It also may apply when driving an external coil driver.