MS1/Extra Updating Your Setup File Only for use with the MS1 Extra code (MS1 - 68H908 based microprocessors) |
|
Before you start any hardware mods please read this entire manual and the Software Manual, available HERE. |
Warning
for
E-Bay buyers!! Please see the Official Suppliers list before buying through E-Bay. This is there for your protection. |
|
Please Note:
All of these instructions / diagrams are to be used at your own risk, like most things there is more than one way to do the same thing, what we have tried to do is to offer a method that we have tested or that others have tested for us. No warranty expressed or implied. Use at your own risk. |
Please follow the insctructions below to change your TunerStudio setup file to the latest for the MS1/Extra firmware.
Step 1. Open your project then press Ctrl + p to open your Project Properties dialog. Check the box for "Show Advanced / Offline Setup" so that you have the drop down menu.
 | 
|
Step 2. Now click on the drop down arrow and notice that the selected firmware / ECU Definition is the last one on the list. The new setup file has the exact same name but it will be about half way up the options list.
 | 
|
Step 3. Now click "OK" and your project will reload automaticly using the new setup file you have just selected.
If you are having trouble selecting the new setup file for your project please contact support@efianalytics.com.
If
you have a question, comment, or suggestion for this FAQ, e-mail Phil
or James or Ken or post it on
the MSnS-Extra forum.
No part of this manual may be reproduced or changed without written permission from Philip Ringwood, James Murray, Ken Culver and Lance.
©2004, 2005 Bruce Bowling and Al Grippo. All rights reserved.