<<Previous page ˆˆTop pageˆˆ This page Next page>> Click here for all of the manuals
MS3X/V3.0 Hardware Guide
In the analogue mode, 0-5V signal is fed into JS4 or JS5 using a protective circuits as in 3.4.9.1. In the internal mode, an add-on card is required. This gives superior knock-sensing control with software 3.4.13.1 Internal Knock Module
The knock module uses a purpose designed knock-sensing amplifier chip to filter knock signals from a standard The module requires soldering to the top of the MS3 card. • First ensure you are confident in this task, if not entrust to someone else or consult your dealer. • Remove the upper case and MS3X card for access. • Position the knock module as shown in line with rear or the DIP40 pins (i.e. adjacent to C3 on the MS3 • Solder on the six connecting pins visible and the two support pins on the other side. (c) 2014-6 James Murray 2016-11-13 Page 40/240 | |||