<<Previous page ˆˆTop pageˆˆ This page Next page>> Click here for all of the manuals
MS3base/V3.0 Hardware Guide
In the analogue mode, 0-5V signal is fed into JS4 or JS5 using a protective circuits as in 3.4.9.1. In the internal mode, an add-on card is required. This gives superior knock-sensing control with software However, the add-on requires that the MS3X spark outputs are used and is not compatible with the "LED" spark 3.4.14 Speed sensor inputs The speed sensors system expects to receive a 0-5V pulsed signal internally at the processor. With some DIY, the spare inputs internally on the mainboard can be used with a suitable interface circuit - such
VR sensors will need a suitable interface circuit to convert the AC signal into a 0-5V pulsed signal. (c) 2014-6 James Murray 2016-11-13 Page 40/222 | |||