<<Previous page ˆˆTop pageˆˆ This page Next page>> Click here for all of the manuals
Trans control setting up and hardware 6.3.2.6 Gear Position
For each gear, specify the analogue voltage at the processor. Some selectors already provide a 0-5V signal from the factory. In other installs, a series of resistors are installed 6.3.2.7 Paddle Shifter
Enable input: Enables paddle-shifting and selects the 'enable' input switch. Active high/low: Selects polarity of paddle enable switch. Output: Selects paddle output, typically this is for the horn. Paddle input: Selects analogue input for paddle shifter. Voltage for UP: Voltage on paddle input to indicate an up-shift. Voltage for DOWN: Voltage on paddle input to indicate an down-shift. Voltage for OUT: Voltage on paddle input to indicate that the output (horn) should be operated. 6.3.3 Shift Curves The shift curves are the main settings for controlling how the transmission behaves and when gear shifts occur. (c) 2014-15 James Murray 2016-01-26 Page 49/60 | |||