Megasquirt Support Forum (MSEXTRA)

Well there you go. I never saw that section before. Many thanks!

Never mind. Got it.

I am trying to activate offline.
I saved the text file to a usb stick and went in side.
I typed www.efianayltics.com/activate and the browser jumps to the tuner studios site.
What is the correct way to do this?

So no body else is seeing non reflective readings on the MPG gauge?

MSQ is attached.

I have my MS set up with the GPS and it reads perfectly. Now I have the AFR set to be stoich at 65 mph and with a 10 gallon tank, get greater than 300 miles before refills. But.... The MPG reading shows 28+ on idle and only 5 mpg when running. In that case, I'd be getting 50 miles to the tank. Did I...

I.ve seen that, but it shows no deviation IIRC.
Just a flat line. Is there something in the config to point that "gauge" to the correct input?

I have the spark triggered by a hall effect sensor on the stock dist. How can I display the trigger on either the logger or a graph in Tunerstudios?

Its 9 pin to 9 pin at COM1.

Any one know why I cant hibernate?

I am running it on a quad Atom with Win 7. Win 7 cant shut the software down to hibernate.

When I place the computer into hibernate, it fails due to the TS still running.
I shortened the kill command to 2000 from 30k in the registry.

Any idea how I can put the system into hibrernate?

sat.msq I built the engine last winter, changing the oil religiously. But not the plugs. (My first engine BTW... The engineers and mechs at work told me to have someone else do it. But I'm stubborn...) I changed the plugs and its running much better, less lean. I'll run it around tomorrow and see h...

MSV3/ VW 2L 16v. I can start the car, but no matter where I set the warm up values the motor runs very lean until it reaches 70 deg C. Once there runs stochic. I raised the warmup way high, then over time reduced the vales. I thought that having it so rich may fool the WB O2 and say its lean, but re...

like the NS 2917?

MS2V3, though not sure of the firmware version. This is for a 1981 VW Scirocco ACN transaxle and the associated cable and the back of a speedo. I have a speedo cable that drives a rotating magnetic disk. The hall effect sensor switches each time the N pole passed. Can the MS be adapted to read this ...

Got it.

Regedit:
local machine
System
Current Control Set
Control: waittokill.
Set this to 2000 not the 30,000 in the registry entry.

I have a windows 7 pro box in the car reading an MS1 V3.
I am trying to get the computer to hibernate, but win 7 will not due to not beiang able to shut down Tuner Studios.

Any idea on how to get this to function correctly?

Can the software set the ignition advance between 5-10 deg when cold?

Ok. The 2719 I know and have in stock.
Sigh.
Wish there were a better way....


Thanks!

I have a hall effect sensor on the end of the speedo cable. I'd like to use that to drive a speedo.
I see VSS mentioned but cant find wiring or gauge set up data.

Thanks!