Search found 4 matches
- Thu Dec 04, 2014 1:47 am
- Forum: MS3 General Support
- Topic: Dying just after startup
- Replies: 4
- Views: 359
Re: Dying just after startup
Thanks Matt, I increased the cranking RPM as well, which was catching the motor as it was trying to stall. Also adjusted the higher end of the ASE up. Didn't want to go too far with the WUE, as it should be 100 once warm anyway. Seems to be starting ok now, need to spend a bit more time on it though...
- Fri Nov 28, 2014 5:20 pm
- Forum: MS3 General Support
- Topic: Dying just after startup
- Replies: 4
- Views: 359
Re: Dying just after startup
I have. It didn't seem to do anything. Can try again of course.
- Fri Nov 28, 2014 2:56 pm
- Forum: MS3 General Support
- Topic: Dying just after startup
- Replies: 4
- Views: 359
Dying just after startup
G'day all, I'm having a little trouble with starting my engine. The motor is a Toyota 18R-GUE with a CT26 turbocharger, 1NZ-FE Yaris coil on plug, 36-1 trigger wheel on the crankshaft. I'm happy that the intake air temperature, coolant temperature and oxygen sensor are accurate. The TPS has been cal...
- Tue Oct 21, 2014 3:07 am
- Forum: MS3 General Support
- Topic: MS3 - progress monitor
- Replies: 222
- Views: 55063
Re: MS3 - progress monitor
After 5 years of building, development, and moving houses a few times, my engine is finally running again!! But as I am starting the tune from scratch, it will take a while before I can move it to the completed step... There seems to be a few gremlins in the system, but I'll try a couple of semi-obv...