When I open up my datalog and open the msq to the data log if I open both ve tables, in the analyze view, then MLV brings up a default afr table... not the one from my tune if I close one of the ve tables and open the afr target table it brings up the one in the tune correctly.
any thoughts? do I need to make a copy of afr table 1 and call it afr table 3?
table switching analyze default afr table?
Moderator: LT401Vette
-
- Master MS/Extra'er
- Posts: 643
- Joined: Sun Nov 06, 2005 12:31 am
- Location: NORTHERN CALIFORNIA
table switching analyze default afr table?
64 el camino, 383 SBC, 11.7 to1 CR, accufab tb/rhs intake, 44lb injectors, trick flow heads, xr292r solid roller cam, belt drive camshaft, dry sump oil system, 2400 stall, turbo 350, spooled 9 inch, strange axles, 3.89 gears, dual wideband, full sequential fuel/cop, MS3x using 1.4.1 code.
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: table switching analyze default afr table?
When in VE Analyze with Advanced Settings visible, right next to the "Hide Advanced Settings" Button, there is a Button to select what target AFR table to use. Can you select your target table from there?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- Master MS/Extra'er
- Posts: 643
- Joined: Sun Nov 06, 2005 12:31 am
- Location: NORTHERN CALIFORNIA
Re: table switching analyze default afr table?
If I tried to open both ve tables to see what was happening in the log then the default afr table showed up, for ve analyzing, if I only have one ve table open at a time, then I can choose the correct afr table for the tune. just cant look at both ve tables 1 and 3 and the afr table 1 at the same time.
I read your instructions..... from above... I didn't realize that the default afr was a button..... yes I can change to the correct afr table... THANKS.
I read your instructions..... from above... I didn't realize that the default afr was a button..... yes I can change to the correct afr table... THANKS.
64 el camino, 383 SBC, 11.7 to1 CR, accufab tb/rhs intake, 44lb injectors, trick flow heads, xr292r solid roller cam, belt drive camshaft, dry sump oil system, 2400 stall, turbo 350, spooled 9 inch, strange axles, 3.89 gears, dual wideband, full sequential fuel/cop, MS3x using 1.4.1 code.