I really thought this was going to be easy! I want to mark log records when AFR Safety System is active. Based on other threads, the following looks right to me, but MLV is rejecting it. What have I done wrong?
Jeff
Custom field for AFR shutdown
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Custom field for AFR shutdown
With no log, I can't say for sure. But my 1st guess would be that you have the s in Status6 in lower case, In most firmware logs I know of it is upper case.
The OutputChannel is lower case, but the DataLog field is Upper.
The OutputChannel is lower case, but the DataLog field is Upper.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- Experienced MS/Extra'er
- Posts: 204
- Joined: Sun Jun 13, 2010 10:33 am
- Location: NorCal USA
- Contact:
Re: Custom field for AFR shutdown
I should have looked at my logs rather than searching the forum. Status6 is indeed capitalized.
Thanks!
Jeff
Thanks!
Jeff