TQ and HP doesn’t work anymore

[arnold1]

My TQ and HP logging used to work fairly well. A couple of months ago it just stopped working. Hp + TQ show min -9.22 max 9.22

See record 126, it jumps from TQ 227.5 to 9.22 to NaN

Also have a very rough AFR 1 Target graph see record 455

Quite a few updates since last year. So what happened or must I change some settings to make it work again??

[LT401Vette]

What is that log from?

Are you using the HP & TQ fields from MLV or the Power and Torque getting logged from TunerStudio?

The TS Logged Power and Torque seem to match your description.

Check the settings in TunerStudio under:
Data Logging --> Power and Economy Fields

[arnold1]

I'm logging from TS see picture. It's the only way I ever do it, always worked before.

[LT401Vette]

Everything looks sane there..
When did it seem to break?
There should have been no changes to that for sometime...
What firmware are you running?

I will need to try reproducing that, perhaps it is related to being in metric?

[arnold1]

Phil, I tried looking up and found the following:

04.25.2014
pretty much ok. 584 HP 553 TQ

11.14.2014
min: -1008 Hp max: 1699 HP way too much

11.17.2014
min: -9.22 HP + TQ max: 9.22 HP + TQ

Firmware: MS3 1.3.2

[arnold1]

Phil, I'm still hoping you will find out why my HP & TQ isn't working anymore.

[Brian H EFI]

arnold1

Phil is currently out of town till the end next week, I will let him know that you are still looking for a solution to get the TQ and HP calculations working.

[arnold1]

Phil, thought I bring up my thread again since nothing has changed.
I even changed vehicle weight and units to lbs, still not working properly.
Strange it worked fairly well until summer 2014 and I think because of an update things got screwed up.