After the auto update to v4.0.18 yesterday I noticed that the blue tail tell thing usually bouncing around in the tuning tables only shows up very randomly, frozen or not at all when running the logs. Same problem on both my computers, W8 laptop and W7 stationary.
Uninstalled the v4.0.18 and reinstalled v4.0.15 and everything worked fine again. Tried the update once more but same problem back.
Have tried different settings without result.
Any advice welcome
Regards JanM
Problems after update
Moderator: LT401Vette
Re: Problems after update
I noticed the same issue after the update.JanM wrote:After the auto update to v4.0.18 yesterday I noticed that the blue tail tell thing usually bouncing around in the tuning tables only shows up very randomly, frozen or not at all when running the logs. Same problem on both my computers, W8 laptop and W7 stationary.
Uninstalled the v4.0.18 and reinstalled v4.0.15 and everything worked fine again. Tried the update once more but same problem back.
Have tried different settings without result.
Any advice welcome
Regards JanM
Bug?
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Problems after update
I was tuning on the dyno today and noticed the same thing....
Should have a fix out tomorrow.
Should have a fix out tomorrow.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Problems after update
4.0.19 is up with this fixed.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- Experienced MS/Extra'er
- Posts: 191
- Joined: Thu Feb 16, 2006 4:21 pm
- Location: Central New Jersey
Re: Problems after update
Thanks Phil!
Re: Problems after update
Thank you! now it's ok