i am running Ms1 v2.2 with the o29y4 firmware, and i am having an issue finding a good list on what all the "Engine bits" mean. anybody have a list they can post up
I am researching this due to a sputter at idle, it when running well, megalog viewer read "137" under engine bits, however when it sputters it reads "9" for 1/10th of a second. upon doing this is also pulls 5 degrees of timing,
What i dont understand is that this entire time, the TPS has not moved, and the MAP is only fluctuating 1-2 kpa.
Engine Bits
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Engine Bits
The Engine bits are displayed on the right side just above the lower readouts.
The green and red indicators that say Crank:, ASE: Warm: Run:, etc.
Those are bits 0 through 7 of the Engine field
The green and red indicators that say Crank:, ASE: Warm: Run:, etc.
Those are bits 0 through 7 of the Engine field
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html