I'm attempting to use MLVHD to do a separate VE analyze for both my cylinder banks, since I'm using the "dual table" option (this is MS2 3.4). Each bank has a separate wideband sensor, logged as Lambda and Lambda2.
In VE analyze, I pick veTable1 and AFR, run the analysis, and it calculates what looks to be a correct VE table 1. Then I repeat this with veTable2 and an "AFR2" that I calculated as Lambda2*14.7, and it looks like it calculates a correct VE table 2. However, when I click on "save tune" and open it in TunerStudio, what I have is a veTable1 that is the 9 lowest load rows from VE table 1 and the 7 higher load rows are the 7 lowest load row from veTable 2. VE table 2 is unchanged.
Is what I'm attempting to do not possible? It looks correct in MLV. I've attached the resulting msq, but the tune file is too big.
Also, is there a way to get VE analyze to use lambda instead of AFR? I find it jarring to suddenly look at AFR values when Tunerstudio is set to work in lambda.
Thanks,
/Patrik J.
VE analyze writes to wrong table?
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: VE analyze writes to wrong table?
Something seems broken here. I have reproduced the problem with your msq.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- Helpful MS/Extra'er
- Posts: 146
- Joined: Sat Apr 11, 2015 2:53 pm
- Location: The island of Hawaii
Re: VE analyze writes to wrong table?
Ok, cool. I can work around it by exporting the tables and importing them in TS, but it would be nice if it worked.LT401Vette wrote:Something seems broken here. I have reproduced the problem with your msq.
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: VE analyze writes to wrong table?
This is fixed for next release.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html