Using my old FAST air/fuel meter which uses 2 Bosch WB sensors. Its been 10 yrs since I did the 07...slowly recalling how I did things. Believe I set up a custom linear output scale: 0.00 volts=10.0 AFR; 4.99 volts=19.98 AFR. But can't remember how I set the target AFR tables and can't find anything in the way of an MLV manual. Any help/suggestions from anybody would be greatly appreciated!
thanks!
Going to try new ver of MLV to remap the new Buell..
Moderator: LT401Vette
-
LT401Vette
- Super MS/Extra'er
- Posts: 12729
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Going to try new ver of MLV to remap the new Buell..
Sorry, but these forums are for MegaSquirt support only. Please contact support <at> efianalytics. com
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html