Can I do this using calculated fields?? Couldn't find anything in search.
A setup formula would be much appreciated as this is a whole new world for me.
Thanks.
Logging EDIS PIP input and SAW output.
Moderator: LT401Vette
-
- Site Admin
- Posts: 39587
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Logging EDIS PIP input and SAW output.
Datalogging isn't fast enough.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- Super MS/Extra'er
- Posts: 17499
- Joined: Thu Apr 16, 2009 8:08 pm
Re: Logging EDIS PIP input and SAW output.
You can record these in an engine log, although the resolution may still be a bit coarse even there and you won't record much else.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Re: Logging EDIS PIP input and SAW output.
Beauty of EDIS is there's no need to. If it sparks standalone, it is likely working just fine. If you connect to MS and TS shows the correct engine RPM, PIP is OK. If it doesn't, check you have the tach input on MS configured correctly. If the sparks follow the MS advance curve SAW is OK. (Best use a timing light to confirm the spark is happening where it should)107merc wrote:Can I do this using calculated fields?? Couldn't find anything in search.
A setup formula would be much appreciated as this is a whole new world for me.
Thanks.
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
MS2 V3
EDIS
Tech Edge O2
London UK.