Logging EDIS PIP input and SAW output.

Questions specific to Megalogviewer

Moderator: LT401Vette

Post Reply
107merc
Experienced MS/Extra'er
Posts: 167
Joined: Fri Mar 28, 2014 10:35 am

Logging EDIS PIP input and SAW output.

Post by 107merc »

Can I do this using calculated fields?? Couldn't find anything in search.
A setup formula would be much appreciated as this is a whole new world for me.
Thanks.
jsmcortina
Site Admin
Posts: 39585
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:

Re: Logging EDIS PIP input and SAW output.

Post by jsmcortina »

Datalogging isn't fast enough.

James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
107merc
Experienced MS/Extra'er
Posts: 167
Joined: Fri Mar 28, 2014 10:35 am

Re: Logging EDIS PIP input and SAW output.

Post by 107merc »

Thanks.
Matt Cramer
Super MS/Extra'er
Posts: 17499
Joined: Thu Apr 16, 2009 8:08 pm

Re: Logging EDIS PIP input and SAW output.

Post by Matt Cramer »

You can record these in an engine log, although the resolution may still be a bit coarse even there and you won't record much else.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
DaveEFI
Super MS/Extra'er
Posts: 4175
Joined: Sun Apr 15, 2012 12:55 am
Location: SW London, UK

Re: Logging EDIS PIP input and SAW output.

Post by DaveEFI »

107merc wrote:Can I do this using calculated fields?? Couldn't find anything in search.
A setup formula would be much appreciated as this is a whole new world for me.
Thanks.
Beauty of EDIS is there's no need to. If it sparks standalone, it is likely working just fine. If you connect to MS and TS shows the correct engine RPM, PIP is OK. If it doesn't, check you have the tach input on MS configured correctly. If the sparks follow the MS advance curve SAW is OK. (Best use a timing light to confirm the spark is happening where it should)
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
Post Reply