Changing the third and fourth graph colors

Questions specific to Megalogviewer

Moderator: LT401Vette

Post Reply
vw_chuck
Master MS/Extra'er
Posts: 633
Joined: Wed Dec 11, 2013 1:16 pm

Changing the third and fourth graph colors

Post by vw_chuck »

I selected to display 4 graphs(16 parameters) on screen but it only allows me to change the color for the first 8 parameters color? How do I change the other 8 parameters colors?
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: Changing the third and fourth graph colors

Post by LT401Vette »

If you have 4 graphs with 4 selectors per graph.

On the Main Menu, select:
Options --> Graph Trace Color

The colors are listed per trace, Graph 1 should be 1-4, Graph 2 should be 5-8, Graph 3 should be 9-12, etc.

As you update the 1st 2, I think you know this so I assume this is not happening this way?
I just tried it and it seems Ok?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Marek
Master MS/Extra'er
Posts: 573
Joined: Sun May 10, 2009 1:20 am
Location: Guildford UK

Re: Changing the third and fourth graph colors

Post by Marek »

Is this a case where the menu disappears under the bottom of the screen because it is a laptop and it has a small screen, so you can't see the remaining menu options?

kind regards
Marek
Post Reply