Car/ms info: 94 miata ms2 extra with jbperf sequential ignition and injection board. using toyota cop
My trigger pulse for my spark is stuck at 5v. I checked my wiring and it seems like everything is ok. Is there a setting in tunerstudio or did i mess up assembling my board?
any help appreciated
thank you
spark trigger stuck at 5v
Moderators: jsmcortina, muythaibxr
Re: spark trigger stuck at 5v
Hall sensor pull up voltage?
Is hall sensor getting power?
Is hall sensor getting power?
Correctly identify your MS ecu here
Read the Do's and Don'ts to avoid the common pitfalls before starting your install or asking for help
Use only these manuals other manuals may cause brain damage or worse.
Read the Do's and Don'ts to avoid the common pitfalls before starting your install or asking for help
Use only these manuals other manuals may cause brain damage or worse.
Re: spark trigger stuck at 5v
There's no setting in tuner studio. Sounds like you wired +5 volts to the JBperf board. Try +12 v instead.
-Alex
-Alex
-
- Super MS/Extra'er
- Posts: 9130
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: spark trigger stuck at 5v
Don't do that.16vboost wrote:Sounds like you wired +5 volts to the JBperf board. Try +12 v instead.
First, you need to give a LOT more information about your setup and your settings. We have next to nothing with your post. Is it a logic-level setup? And where did you measure 5V? Have you tried the test mode.
And:
Jean
Re: spark trigger stuck at 5v
i am sorry for wasting your guys time . i miss understood the concept of coils and figured it out.
Re: spark trigger stuck at 5v
No time wasted. We're here to help each other.