R33 for V3.0 board MS2

All questions about MS2/Microsquirt/Microsquirt module. See also MS2/Extra manuals

Moderators: jsmcortina, muythaibxr

Post Reply
efims
Helpful MS/Extra'er
Posts: 130
Joined: Sun Oct 30, 2011 8:59 am

R33 for V3.0 board MS2

Post by efims »

From the assembly manual

"Even if you have installed the PWM flyback damping circuit, you should install the standard flyback circuit as well (step #70).

70. To install the standard flyback circuit:

Install R18 and R33 {270QBK-ND, red-violet-brown}. These are located below R38 and Q1 on the heat sink."

I ran out of 270 Ohm...but I have a few 330 Ohm....can I use 330 Ohm for R33?

Thanks in advance
damon308
Experienced MS/Extra'er
Posts: 307
Joined: Tue Nov 17, 2009 7:36 am

Re: R33 for V3.0 board MS2

Post by damon308 »

Hi, Yes that should be fine, Regards DM
Post Reply