Page 1 of 1

R33 for V3.0 board MS2

Posted: Thu Jun 14, 2012 5:52 am
by efims
From the assembly manual

"Even if you have installed the PWM flyback damping circuit, you should install the standard flyback circuit as well (step #70).

70. To install the standard flyback circuit:

Install R18 and R33 {270QBK-ND, red-violet-brown}. These are located below R38 and Q1 on the heat sink."

I ran out of 270 Ohm...but I have a few 330 Ohm....can I use 330 Ohm for R33?

Thanks in advance

Re: R33 for V3.0 board MS2

Posted: Fri Jun 15, 2012 4:04 am
by damon308
Hi, Yes that should be fine, Regards DM