Hello, I have a VR6 12v motor on MS2v3. I am noticing that the plugs on my cyls 1,3,5 are burning lean compared to 2,4,6 and was wondering if there is a rough guideline on adjusting the trim for that bank of injectors to provide some more fuel.
I do not have a WB connected to the individual cylinders, so I would be unable to test the AFR, but adjusting and re-checking plugs / temps for those cyls should allow me to dial it in better than it is currently. Could anyone advise on this, or which setting would have to be adjusted to provide more fuel?
Bank 2 are default values, Bank 1 are the settings I normally use for both.