Parrallel Install
Moderators: jsmcortina, muythaibxr
Parrallel Install
I'm about in wire up my MSII, but need to keep the oem pcm to control the trans. I plan to splice into the oem harness near to oem pcm. My question is. Can use (t into) the switched ignition from the oem pcm to power the MSII?
Re: Parrallel Install
Do you want spark control?
What kind of crank sensors do you have?
You can do fuel only off the coil negative...
What kind of crank sensors do you have?
You can do fuel only off the coil negative...
Correctly identify your MS ecu here
Read the Do's and Don'ts to avoid the common pitfalls before starting your install or asking for help
Use only these manuals other manuals may cause brain damage or worse.
Read the Do's and Don'ts to avoid the common pitfalls before starting your install or asking for help
Use only these manuals other manuals may cause brain damage or worse.
Re: Parrallel Install
Yes, I want fuel and spark control. I plan on getting a 36-1 trigger wheel. This is going on an 01 Dodge Dakota with a v6.
Re: Parrallel Install
Power for the MS should come from a main power relay as shown in the manual.
page 14
page 14
Correctly identify your MS ecu here
Read the Do's and Don'ts to avoid the common pitfalls before starting your install or asking for help
Use only these manuals other manuals may cause brain damage or worse.
Read the Do's and Don'ts to avoid the common pitfalls before starting your install or asking for help
Use only these manuals other manuals may cause brain damage or worse.