Hi!
Just have a quick question.
I am developing a mainboard for the microsquirt module and i want to incorporate the HC-06 bluetooth module onto the board. But is it possible to connect the TX and RX terminals of the HC-06 to TXOUT and RXOUT of the Microsquirt module?
The reason i'm wondering is that normally when i use the HC-06 with a regular megasquirt, i connect the HC-06 straight to the cpu. So would it even be possible to route it through the MAX3221 of the Microsquirt?
Kim
HC-06 bluetooth module and Microsquirt Module?
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 142
- Joined: Thu Oct 18, 2012 6:20 pm
Re: HC-06 bluetooth module and Microsquirt Module?
My thoughts are you might have to run in through another 2nd max232 or max3221 to step it back down for the module
Sent from my SM-N920I using Tapatalk
Sent from my SM-N920I using Tapatalk
Re: HC-06 bluetooth module and Microsquirt Module?
I see, so basically connect it like the "isolated usb interface circuit"? Since the FT232RL is also designed to connect straight to an MCU?
Re: HC-06 bluetooth module and Microsquirt Module?
I had to connect the HC05 straight to the Microsquirt Module TTL lines.
-
- Super MS/Extra'er
- Posts: 1986
- Joined: Sat Jul 22, 2006 8:02 pm
- Location: Eureka, NV USA
- Contact:
Re: HC-06 bluetooth module and Microsquirt Module?
Hmmmmm........ interesting..........kim_gulle wrote:I am developing a mainboard for the microsquirt module
For what purpose, may I ask?
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance