What to do with IACENBL pin? (micro module)

[jeff01]

I´ve searched but havent found.... When I want to use PT6 and PT7 outputs then I always have to connect something to IACENBL pin? what does it needs? ground, +5 or +12?
I think it´s not +12 and I think I´m mistaken something but I´ve some experience with ms2 what needed wire wetween 12v and some pin to get IAC outputs working.

Thanks A lot

[jsmcortina]

It is an output, leave it open.

If you connect 12V to it you'll destroy the processor for sure.

James

[jeff01]

thanks But is it useable somehow too for something?
I´m installing micro on a subaru and client wants to get as much extras as possible and I´ve already out of them I think.....sequential spark, boost cntrol, idle, tach, tank solenoid, launch, fan, flex etc

[hybrid]

If you want more I/O you can add an IOX box and connect it to CAN.

[dontz125]

It has no selectable function in the code. If you want it to do something, you'll have to write it into the code, then compile.