24-1 with second trigger ?
Moderators: jsmcortina, muythaibxr
24-1 with second trigger ?
Will the jim stim simulate a 24-1 crank with a single trigger on the cam as a second trigger? If not how would one go about setting it up to work ?
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
There isn't an existing mode for 24-1 on the crank and a single cam trigger. But is that what you really mean?
If you want 24 teeth non-missing on the crank and 1 tooth on the cam then yes - it is called "LS1"
James
If you want 24 teeth non-missing on the crank and 1 tooth on the cam then yes - it is called "LS1"
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Yeah its 24-1 on the crank i looked last night just to make sure as i thought i might be wrong. And it has a single second single trigger on the cam.
This is for a Motorcycle engine. I aslo have a 8 tooth flywheel for the same motor but i what to setup whatever is the best trigger wheel setup for the motor i have plenty of time to setup either one i just want the one that will be the most accurate timming wise .
Im also going to be running the MS2 Extra code and COP set not WS
Thanks for any help im all ears.LOL
This is for a Motorcycle engine. I aslo have a 8 tooth flywheel for the same motor but i what to setup whatever is the best trigger wheel setup for the motor i have plenty of time to setup either one i just want the one that will be the most accurate timming wise .
Im also going to be running the MS2 Extra code and COP set not WS
Thanks for any help im all ears.LOL
-
- Helpful MS/Extra'er
- Posts: 121
- Joined: Tue Jul 06, 2004 11:27 pm