injection led on pcb not flashing

Building and using the Stimulator to test your Megasquirt

Moderators: jsmcortina, muythaibxr

Post Reply
nissag250
MS/Extra Newbie
Posts: 7
Joined: Wed Dec 09, 2009 6:36 am
Location: France ( old europe )

injection led on pcb not flashing

Post by nissag250 »

Hi, i just assembled my MS 2 V.3 PCB, when i switch on the stim, all leds are flashing correctly, except the LED 14 on the megasquirt ( injection led )
i tested and the signals to injectors on the db 37, are good,( 28-32/33 and 28-34/35 ) the led herself is ok,i think it's the transistor that is fried ?
what can i do

second question : i have an EDIS 6, and in the megatune, it's rising edge, and in the ms 2extra, it's falling edge , so what is right ?
excuse my bad english, i'm french !
Post Reply