Hey guys, new member, first post. I built a JimStim v1.5 yesterday (my first foray into wiring other than guitars) and when I was done with the instructions, had a F1 thingy leftover. I found it's place on the PCB and installed it, and everything fired up and tested fine, but I wanted to make sure I didn't turn on some wierd option I don't need or something. Thanks!
JimStim v1.5 F1?
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 9130
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: JimStim v1.5 F1?
F1 is a polyfuse that will protect the JimStim and the MS from too much current if something goes wrong.
Jean
Jean
-
- Master MS/Extra'er
- Posts: 548
- Joined: Fri Dec 10, 2010 4:41 pm
Re: JimStim v1.5 F1?
Thanks!