I'm using the Jimstim 2.03 controller.
The table (for dipswitch settings) says no cam signal available for the 60-2 wheel pattern, but when i studied the wheel pattern .txt file, it shows that there is a cam signal in this wheel pattern.
I,m confused now, is there a cam signal or not?
I wat to use the cam signal for triggering my scope.
Does 60-2 wheel provide a cam signal or not
Moderators: jsmcortina, muythaibxr
-
- MS/Extra Newbie
- Posts: 18
- Joined: Tue Nov 26, 2013 3:46 pm
Re: Does 60-2 wheel provide a cam signal or not
? The wheel selection table I'm looking at shows a '2ndtach signal' for the 60-2 pattern.
Temporarily shut down - back soon!
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
-
- Super MS/Extra'er
- Posts: 9130
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: Does 60-2 wheel provide a cam signal or not
The 'X' in the table indicates that the cam signal is present.
Jean
Jean
-
- MS/Extra Newbie
- Posts: 18
- Joined: Tue Nov 26, 2013 3:46 pm
Re: Does 60-2 wheel provide a cam signal or not
Nice
Thanks for the quick answers
(Stupid from me, was thinking "X" ment no cam signal)
Thanks for the quick answers
(Stupid from me, was thinking "X" ment no cam signal)