Megasquirt Support Forum (MSEXTRA)

I'm using the Jimstim 2.03 controller.

The table (for dipswitch settings) says no cam signal available for the 60-2 wheel pattern, but when i studied the wheel pattern .txt file, it shows that there is a cam signal in this wheel pattern.
I,m confused now, is there a cam signal or not?

I wat to use the cam signal for triggering my scope.

? The wheel selection table I'm looking at shows a '2ndtach signal' for the 60-2 pattern.

The 'X' in the table indicates that the cam signal is present.

Jean

Nice

Thanks for the quick answers

(Stupid from me, was thinking "X" ment no cam signal)