Jimstim1.5 Flex fuel test
Moderators: jsmcortina, muythaibxr
Jimstim1.5 Flex fuel test
I have a ms3x trying to configure flex fuel sensor. I turned it on in tuner studio and placed jumper from flex input on the stimx to the spare pointometer on the jimstim, brought up ethonal% gauge but nothing happens. Tried using another input besides the flex-in on the ms3x but same result. Has anyone simulated this in test mode?
-
- Super MS/Extra'er
- Posts: 9130
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: Jimstim1.5 Flex fuel test
The flex fuel signal is not an analog 0-5V signal but a PWM signal. The JimStim can't simulate that.
Jean
Jean
Re: Jimstim1.5 Flex fuel test
Oh okay didn't realize that. Is there anyway to configure something to simulate a pwm?
-
- Super MS/Extra'er
- Posts: 9130
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: Jimstim1.5 Flex fuel test
You could try to use the tach signal with the distributor wheel pattern. That might work for a small RPM range but I haven't tried and won't be able to since I don't have an MS3 test setup available.
Other than that there is nothing on the JimStim that can simulate a PWM signal.
Jean
Other than that there is nothing on the JimStim that can simulate a PWM signal.
Jean