Jimstim 2.0 + cpu 2.0.4 weird Wheel wave
Posted: Fri Mar 13, 2015 12:02 am
Recently my jimstim cpu 2.0.2 was burned out and start to get hot, soo i read about this on jbperf site and did the tests to get the correct diagnostic and the result is CPU FAULT.
I got two new cpu from DIYAUTOTUNE and they come with new firmware 2.0.4.
Installed the CPU and every goes good, no more hot cpu.
The first test i did was the wave format of wheel to start calibrate my MS2v3 but for my surprise the wave showed was different from the old cpu 2.0.2.
I would like to be oriented to get the correct wave format to produce the correct wave like on 2.0.2 firmware.
obs: No metters if i choose Hall or VR simulator, the wave remains the same.
I got two new cpu from DIYAUTOTUNE and they come with new firmware 2.0.4.
Installed the CPU and every goes good, no more hot cpu.
The first test i did was the wave format of wheel to start calibrate my MS2v3 but for my surprise the wave showed was different from the old cpu 2.0.2.
I would like to be oriented to get the correct wave format to produce the correct wave like on 2.0.2 firmware.
obs: No metters if i choose Hall or VR simulator, the wave remains the same.