I have the JimStim 1.5 and I just laid it out on the table to make sure it's all there and getting ready to assemble it.
After I read through the entire assembly instructions, I have four pieces left over. The labels on the bag read:
(3) 3x2 header double row
(7) Shunts
(3) Wire Jumpers for .1" headers
And the last bag is not labeled. But it's just the 9v battery piece.
Do I not need to install these pieces? I'm VERY new to electronic assembly. Sorry if this is a very basic question.
extra parts...?
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 9128
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: extra parts...?
Step 8 shows you where the headers go. And the shunts and wire jumpers will be installed when you configure your JimStim for the signals you will need for your setup: http://www.jbperf.com/JimStim/JimStim_v ... .html#tach
Jean
Jean