extra parts...?

Building and using the Stimulator to test your Megasquirt

Moderators: jsmcortina, muythaibxr

Post Reply
sen2two
MS/Extra Newbie
Posts: 29
Joined: Thu May 07, 2015 9:00 pm

extra parts...?

Post by sen2two »

I have the JimStim 1.5 and I just laid it out on the table to make sure it's all there and getting ready to assemble it.

After I read through the entire assembly instructions, I have four pieces left over. The labels on the bag read:

(3) 3x2 header double row

(7) Shunts

(3) Wire Jumpers for .1" headers

And the last bag is not labeled. But it's just the 9v battery piece.

Do I not need to install these pieces? I'm VERY new to electronic assembly. Sorry if this is a very basic question.
racingmini_mtl
Super MS/Extra'er
Posts: 9128
Joined: Sun May 02, 2004 6:51 am
Location: Quebec, Canada
Contact:

Re: extra parts...?

Post by racingmini_mtl »

Step 8 shows you where the headers go. And the shunts and wire jumpers will be installed when you configure your JimStim for the signals you will need for your setup: http://www.jbperf.com/JimStim/JimStim_v ... .html#tach

Jean
jbperf.com Main site . . . . . . . . . . . . . . . . . . . . . . jbperf.com Forum
Image
Post Reply