JimStim 1.5 Questions

Building and using the Stimulator to test your Megasquirt

Moderators: jsmcortina, muythaibxr

Post Reply
Ghostin
MS/Extra Newbie
Posts: 16
Joined: Sat Sep 19, 2015 5:18 pm

JimStim 1.5 Questions

Post by Ghostin »

Hoping to get some help...
Is there a DB37 connector pinout list detailing which pin is what. Would like to make a jumper harness from DB37 to Microsquirt utilizing the DB37 connector but I cannot find the pinout list. I have seen the jimstim to microsquirt utilizing the board blocks but I would like the pinouts for 1.5/ 2.0 if they are different. Any help is appreciated.

Also when testing my IAC led's my IAC2 will not light, but will light when testing tach signal so I know led is good..all solders look good...any thoughts?

Thanks Guys
racingmini_mtl
Super MS/Extra'er
Posts: 9128
Joined: Sun May 02, 2004 6:51 am
Location: Quebec, Canada
Contact:

Re: JimStim 1.5 Questions

Post by racingmini_mtl »

The DB37 pinout is shown in the MS2 (or MS3) manual in the schematics section. You also have the pin numbers on board silkscreen besides the 19-pin header. And use the FIdle LED for your IAC; the IAC LEDs on the JimStim are for a stepper motor IAC (which is not supported by the Microsquirt).

Jean
jbperf.com Main site . . . . . . . . . . . . . . . . . . . . . . jbperf.com Forum
Image
Ghostin
MS/Extra Newbie
Posts: 16
Joined: Sat Sep 19, 2015 5:18 pm

Re: JimStim 1.5 Questions

Post by Ghostin »

Thank you.
Post Reply