Custom Trike with multiple controllers and CAN Dash
Posted: Thu Dec 18, 2014 12:24 pm
This entire project isn't quite done yet but my part of is close enough that it's time to call it success.
What it is: Custom trike with a 2005 Pontaic Sunfire powertrain.
What it's got: 2.2L Ecotec engine with the factory Ion sense ignition. Being controlled with an MS3-Pro.
Hydramatic 4T40E automatic transmission. Being controlled with a V3.0 Microsquirt running James' transmission firmware.
AIM MXL Strada Dash for driver info.
All 3 units are tied together on the CAN bus. I did have to remove R18 ( CAN bus terminating resistor) from from the uS. The uS gets RPM, ECT and TPS from the 3-Pro. The 3-Pro gets VSS from the uS and the AIM gets it's data from the 3-Pro.
What it is: Custom trike with a 2005 Pontaic Sunfire powertrain.
What it's got: 2.2L Ecotec engine with the factory Ion sense ignition. Being controlled with an MS3-Pro.
Hydramatic 4T40E automatic transmission. Being controlled with a V3.0 Microsquirt running James' transmission firmware.
AIM MXL Strada Dash for driver info.
All 3 units are tied together on the CAN bus. I did have to remove R18 ( CAN bus terminating resistor) from from the uS. The uS gets RPM, ECT and TPS from the 3-Pro. The 3-Pro gets VSS from the uS and the AIM gets it's data from the 3-Pro.