Hi David....
Any development on having CAN Access and pass through?
So we can access GPIO and Etc... Something like TS?
Cheers!
Megatunix and CAN Pass through
Moderator: djandruczyk
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Megatunix and CAN Pass through
But wait... you just said you don't use MS2 (for suby wheel)? MS1 doesn't support CAN.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- MS/Extra Guru
- Posts: 1210
- Joined: Fri May 07, 2004 6:55 pm
- Location: Rochester, NY, U.S.A.
- Contact:
Re: Megatunix and CAN Pass through
phoenix3d wrote:Hi David....
Any development on having CAN Access and pass through?
So we can access GPIO and Etc... Something like TS?
Cheers!
Can passthrough isn't working yet, i need to find the time to get my gpio board wired to my ms2 for testing purposes.
David J. Andruczyk
MegaTunix author. The only non-java cross platform tuning software for MS-I/II hardware.
Where to get and how to install:
http://msextra.com/viewtopic.php?t=23080
http://sourceforge.net/projects/megatunix
MegaTunix author. The only non-java cross platform tuning software for MS-I/II hardware.
Where to get and how to install:
http://msextra.com/viewtopic.php?t=23080
http://sourceforge.net/projects/megatunix