I feel a bit silly asking this.
I have just migrated fully form MT, to TS, and I had calibrated everything like TPS, AFR, CLT, IAT in MT. It's a MS2 Extra setup.
Now I'm using TS, do I have to recalibrate any of the sensors? The values look sane, so i don't think so, but just checking
Cheers,
Kristian
Very easy question about calibration
Moderator: LT401Vette
Very easy question about calibration
Constantly evolving;
4 cylinder n/a, 16v 1368cc Fiat Seicento
4 cylinder n/a, 16v 1368cc Fiat Seicento
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Very easy question about calibration
Nope, for you on MS2 all the calibrations are in the Controller so any calibrations done with MegaTune will be seen by TunerStudio and it works the other way as well. There is no need to re do them.
For Users of MS1 & MS1 Extra, calibrations are written to inc files and will either need to moved to the project or redone (TPS Calibration).
For Users of MS1 & MS1 Extra, calibrations are written to inc files and will either need to moved to the project or redone (TPS Calibration).
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Re: Very easy question about calibration
Thats what i though. Thanks for confirming Phil
Constantly evolving;
4 cylinder n/a, 16v 1368cc Fiat Seicento
4 cylinder n/a, 16v 1368cc Fiat Seicento