36-1 setup confusion

[ausloki]

Ok, got the last update and looking at the trigger setup i'm trying to understand how to configure this trigger wheel setup/trigger return or edis setup.

my current setup on another MS is with a 36-1 trigger wheel running wasted spark coil pack scenario. Sensor is positioned as per edis setup (6 teeth) or 60 degrees if you like. what would i need to set the trigger angle/offset at for a KL series engine

what would be the best configuration so to speak

[Matt Cramer]

Which MS version is this, and what firmware is it running?

[ausloki]

Sorry. MSII MS2Y i beleive

[Matt Cramer]

Try the settings at the very bottom of this page.

http://www.diyautotune.com/tech_article ... erview.htm

[ausloki]

Thanks for that Matt, My settings are almost identical to those. The only difference is these instructions state to set the number of missing teeth as two when i only have a 36-1 wheel on my crank. and i have mine set to one.

[Matt Cramer]

Thanks for that Matt, My settings are almost identical to those. The only difference is these instructions state to set the number of missing teeth as two when i only have a 36-1 wheel on my crank. and i have mine set to one.

My mistake, that was a typo. The article is now fixed.