I was using TS to tune my Ms2 Extra 2.1.0 beta 20090225 with.
Wanted to make change on the MAT correction table.
With MT I set my temp bins for 0,10, 20, 30, 40, 60 deg C but the ini file only starts at 100deg C going upwards from there (obviously needs changing in the ini file).
1) With TS I found that using left and right arrow I could see the 40 and 60 points coming up but I could not adjust them using shift up/down or ctrl shft up/down. Does TS only allow adjustment if the points are actually on the graph?
2) Would be nice to change the graph properties in a similar way one can change the gauges. I found other graphs boundaries also not to my liking (adjustable in the ini) but if one could adjust them on the graph...
