Message after FirmWare Upgrade

[Stag76]

I upgraded an MS1 running MSNs to Firmware rev 029y4, and I now get the following message when I open the project

"Failed to Subscribe DashComp to OutputChannel FIdle/Spark OnOC
Please Set to a Valid Output Channel"

The FIdle/Spark Label at the bottom of the screen is highlighted with a Red Border.

What do I have to change?

[65looter]

I believe you need to enter the 'designer mode' and edit that gauge.

[LT401Vette]

What happened is, apparently one of the indicators on your dash have been retired in the new firmware.

You can handle that a few ways:

Right click on the Indicator that has the red circle and cross through it, select a new "Indicator Template" that is valid for your new firmware.

or

Right click, select "Designer Mode" change the indicator, or just remove it from your dash by,
right click --> "Remove From Dash"

or

Right click --> "Load / Save" --> "Load Dashboard"
then select any of the dashboards in the dialog, those will be for your new firmware.