I noticed this while testing out the us. module with the newest 3.0.3h sequential code from Jean, it seems to only burn one page at a time then the popup comes up saying controller and TS dosent match you end up having to hit "Use TS settings" a few times ( depending on how many changes are in the msq) before it writes the whole msq file ,it also takes a long time to write even a fuel table.
I checked with MT just to make sure it wasn't the us. module's serial chip or something but it loads fine in MT.
Now i also checked this with a standard MS 2.2 board with MS2 card and it loads fine in TS it burns all pages the first time, it just happens with the us.Module.
I have attached the msq i was testing with this is with my desktop computer with a true serial port also running XP.
Slow msq burn with us Module
Moderator: LT401Vette
Slow msq burn with us Module
2000 Suzuki Hayabusa turbo MS3 beta testing Plug and Play standalone
http://interfacepnp.webs.com/
http://www.youtube.com/Busams
http://interfacepnp.webs.com/
http://www.youtube.com/Busams
-
- Super MS/Extra'er
- Posts: 9130
- Joined: Sun May 02, 2004 6:51 am
- Location: Quebec, Canada
- Contact:
Re: Slow msq burn with us Module
Did you load the correct uS s19 file and use the correct uS ini file? Also, did you activate MICROSQUIRT_MODULE and deactivate MICROSQUIRT_FULL in the ini?
Jean
Jean
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Slow msq burn with us Module
Another thing to check is the Setting CAN_COMMANDS is not on.
If that is on you will make a lot of extra calls that aren't needed unless you are communicating to it remotely.
If that is on you will make a lot of extra calls that aren't needed unless you are communicating to it remotely.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Re: Slow msq burn with us Module
I turned the CAN COMMANDS off and that fixed it . Thanks guys.
2000 Suzuki Hayabusa turbo MS3 beta testing Plug and Play standalone
http://interfacepnp.webs.com/
http://www.youtube.com/Busams
http://interfacepnp.webs.com/
http://www.youtube.com/Busams