rasberry pi integration

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Re: rasberry pi integration

Postby theduck » Sun Jan 29, 2017 3:48 pm

If I remember correctly you can move windows by pressing alt and then click and drag
Ford Pinto (Euro 4cyl 2.0l SOHC) with TF035 Turbocharger - Now powered by MS2 V3.0 running MS2/Extra 3.4.2.
User avatar
theduck
Helpful MS/Extra'er
 
Posts: 36
Joined: Sun May 15, 2016 7:53 am

Re: rasberry pi integration

Postby LSXCutty » Sun Jan 29, 2017 4:15 pm

That worked thank you
LSXCutty
Helpful MS/Extra'er
 
Posts: 113
Joined: Tue May 10, 2016 5:00 am

Re: rasberry pi integration

Postby LSXCutty » Wed Feb 08, 2017 12:52 pm

I'd like to hear how some of you are optimizing your boot ups. Right now its taking just over 60 seconds from power on until tuner studio is up and running. Any suggestions.
LSXCutty
Helpful MS/Extra'er
 
Posts: 113
Joined: Tue May 10, 2016 5:00 am

Re: rasberry pi integration

Postby acedeuce802 » Wed Feb 08, 2017 2:33 pm

Are you on Raspbian Jessie? Run *systemd-analyze blame* (without the *'s) in terminal. This will show you how long each service took to boot. The longest boot times are obviously the ones you want to focus on. My longest service was hciuart.service, which is bluetooth related. I did not need this so I commanded *sudo systemctl disable hciuart*. You can look up the other services that add lots of time too boot, and figure out if you need them. Save a copy of your image before doing stuff you're not 100% confident in, in case you mess up something.

A lot of people have success with SamplerBox, but it didn't help so much for me, YMMV: http://www.samplerbox.org/article/fastbootrpi

Also make sure you're using a fast SD Card. I'm using a PNY 85 mb/s card. With that card, the above that I mentioned, it takes 15 seconds to boot to the LXDE desktop, then 7 seconds to have TunerStudio loaded. With this setup, I haven't yet got a TunerStudio Project loaded, but I can't imagine that would add more than 5-10 seconds. So in total about 30 seconds from power on to showing gauges.
acedeuce802
Helpful MS/Extra'er
 
Posts: 37
Joined: Mon Sep 29, 2014 5:57 pm

Re: rasberry pi integration

Postby remsperso » Wed Feb 08, 2017 2:55 pm

My RPi2 takes 35s to show values on gauges, connected to the MS.
I haven't optimized boot and I display a video during startup. Wifi is always activated because sometimes I share internet connection with my smartphone, to access the MS remotely.
https://youtu.be/IWfGvrZ6r3Q
remsperso
MS/Extra Newbie
 
Posts: 24
Joined: Tue Nov 23, 2010 5:06 am

Previous

Return to Tuner Studio

Who is online

Users browsing this forum: No registered users and 3 guests