theduck wrote:Just spent my afternoon setting my new pi3 and screen up and got tunerstudio running and it all running well, so started tweaking boot times, found a set of recommneded commands to run and now fubar. Oh well, it was only a few hours work...
VLC-05L wrote:Not sure if this is the correct section, but I will add it here and see how I go.
I'm in the process of setting up a Pi dash. I think I have most of it sorted, except for the fuel gauge.
I know I can make a circuit and use JS4/AD7 as input into the MS, then get that value into Tunerstudio and make a custom gauge. I do however want to keep that input open in case I want to fit a knock sensor. I have already used JS5/AD6 for a real time barro sensor.
I think there is a way to get the fuel gauge sensor reading into the RPi3. What I was hoping for was a way to get the sensor reading from the Pi into tuner studio and into a gauge. I have played with TS and couldn't see anything obvious that would suggest that it is possible, but I'm no expert.
Has anyone done anything like this before? Anyone have links to some advice about this?
piledriver wrote:Nice looking setup!
What was model of unit?
Users browsing this forum: No registered users and 3 guests