Error Mesage

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

turbo conversion
Super MS/Extra'er
Posts: 1281
Joined: Thu Aug 19, 2010 6:22 pm
Location: White House, TN USA

Re: Error Mesage

Post by turbo conversion »

Hi Phil, that took care of it :D you are the man.

Thanks, David
1976 Datsun 280Z L28ET Garrett GT35R T3-T04E stage3 50 trim 63 A/R housing custom grind cam 2000-6000 rpm 440cc injectors intercooled 18 lbs. boost
3" exhaust turbo back LC-1 o2 sensor Hallman manual boost controller EDIS 6 ignition batch fire 60mm throttle body 5 spd T5 borg warner 3.54 lsd
Flaming_Crossbow
MS/Extra Newbie
Posts: 16
Joined: Mon Mar 27, 2017 12:09 am

Re: Error Mesage

Post by Flaming_Crossbow »

This is the only thread i found while searching error message "Content is not allowed in prolog". So i decided to post my question here to keep the subject centered.

I an fiddling around with tunerstudio (Running the MS2-Extra-Example file, No MS connected).
I generated and loaded an ignition and afr table as instructed in the megamanual without issues.

I also tried the VE table generator on megamanual to create an Initial VE table for my engine. But i get this error when trying to load it into my project.

Is used the following settings:
Idle RPM is 600 RPM
Est idle vac. Is 24 Hg
RPM redline is 12000 RPM
Peak flywheel hp is 100hp @ 12000 RPM
Peal torque is 50 lbft @ 10500 RPM
Engine displacement is 0.75 L
Engine max boost is 0 psi

Next save as VEX file via notepad.

When i load it in Tunerstudio i get the "Content is not allowed in prolog" why am i getting this error with the VE table?
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: Error Mesage

Post by LT401Vette »

Can you post the file you are trying to load?
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Post Reply