Programmable output status

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
hardline
Master MS/Extra'er
Posts: 503
Joined: Mon Sep 08, 2008 8:37 pm
Location: Peoria, IL

Programmable output status

Post by hardline »

Maybe I just missed it, but is there a way to configure an indicator to show the status of a programmed output?
2000 ZX2 : Sequential COP, MS3 + MS3X + TinyIOx, PWM Returnless Fuel, Flex Fuel, Variable Geometry Intake Manifold, Garrett GTX2863R .82AR housing @ 15 psi
Top
kjones6039
Super MS/Extra'er
Posts: 1986
Joined: Sat Jul 22, 2006 8:02 pm
Location: Eureka, NV USA
Contact:
Contact kjones6039

Re: Programmable output status

Post by kjones6039 »

Indicators are easy to create/configure in TS. Just right click on your TS screen and select Designer Mode

Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
Top
hardline
Master MS/Extra'er
Posts: 503
Joined: Mon Sep 08, 2008 8:37 pm
Location: Peoria, IL

Re: Programmable output status

Post by hardline »

I know how to add gauges and indicators, but I do not see any options that would correlate with the programmed output. It is using Injector G and it changes the intake manifold from long runner to short runner. I used to be able to hear the difference when N/A, but now that it is turbocharged, I no longer hear the change in resonance.
2000 ZX2 : Sequential COP, MS3 + MS3X + TinyIOx, PWM Returnless Fuel, Flex Fuel, Variable Geometry Intake Manifold, Garrett GTX2863R .82AR housing @ 15 psi
Top
jsmcortina
Site Admin
Posts: 39618
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:
Contact jsmcortina

Re: Programmable output status

Post by jsmcortina »

Add an indicator for the raw i/o port itself (e.g. PORTA6)

Ref: http://www.msextra.com/doc/ms3/hardware.html#pins

James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Top
Post Reply

Return to “Tuner Studio”