Hi!
I have registered Tuner Studio and so it's on both my desktop and my netbook. The only way I can connect to the ECU is through BlueTooth. Is it possible to have both computers connected to the ECU with Tuner Studio at the same time?
Also, if I leave the boot load jumper installed I seemed to have a hard time connecting. I started to think maybe this is a safety feature or was it just a bad connection?
Run two instances on one vehicle?
Moderator: LT401Vette
-
- Master MS/Extra'er
- Posts: 385
- Joined: Thu Jul 17, 2014 4:44 pm
Run two instances on one vehicle?
Thanks you;
Ernie
Ernie
-
- Super MS/Extra'er
- Posts: 4122
- Joined: Fri May 07, 2004 3:33 am
- Location: Australia
Re: Run two instances on one vehicle?
Boot jumper is only to be installed when upgrading from certain firmwares or in the case of reloading new over a corrupted firmware. Otherwise it is not to be connected/jumped.
Find the Manuals up top under Quick links: Manuals.
Cheers Luke
Cheers Luke
-
- Master MS/Extra'er
- Posts: 385
- Joined: Thu Jul 17, 2014 4:44 pm
Re: Run two instances on one vehicle?
Thanks!
Any idea on whether I can have two computers running TS on the same vehicle?
Any idea on whether I can have two computers running TS on the same vehicle?
Thanks you;
Ernie
Ernie
-
- Super MS/Extra'er
- Posts: 4122
- Joined: Fri May 07, 2004 3:33 am
- Location: Australia
Re: Run two instances on one vehicle?
I very much doubt it is possible. The blue tooth device should only "pair" with one other device.
Find the Manuals up top under Quick links: Manuals.
Cheers Luke
Cheers Luke
Re: Run two instances on one vehicle?
Don't think so - but easy to copy the current tune into the correct project directory? If you do this frequently, put a short cut to it on each of the computer's desktops. I do this with log files so I can view more easily on a bigger monitor.ErnieJones wrote:Thanks!
Any idea on whether I can have two computers running TS on the same vehicle?
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
MS2 V3
EDIS
Tech Edge O2
London UK.
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Run two instances on one vehicle?
Only 1 device can talk to the MegaSquirt at a time.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html