Feature request: Closed loop PID autotune
Moderator: LT401Vette
-
- Helpful MS/Extra'er
- Posts: 147
- Joined: Tue Oct 27, 2009 3:49 pm
- Location: Norway
Feature request: Closed loop PID autotune
Hi, is it possible to include Autotune of the closed loop idle control and perhaps the boost control in Tunerstudio ?
-
- Super MS/Extra'er
- Posts: 12731
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: Feature request: Closed loop PID autotune
Anything is possible I suppose
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
-
- Site Admin
- Posts: 8230
- Joined: Thu Oct 14, 2004 12:48 pm
Re: Feature request: Closed loop PID autotune
The most important thing to tune in both cases is the initial values/bias table respectively.
PID actually isn't that hard to tune once those are tuned (and for idle the parameters that enable PID in the first place).
Ken
PID actually isn't that hard to tune once those are tuned (and for idle the parameters that enable PID in the first place).
Ken
Megasquirt is not for use on pollution controlled vehicles. Any advice I give is for off road use only.