settings for edis in tuner studio
Moderator: LT401Vette
-
- MS/Extra Newbie
- Posts: 3
- Joined: Sat May 16, 2015 6:39 pm
settings for edis in tuner studio
Ok so I am running ed is4 with the modual, and I keep seeing g to set it to going high inverted, well there is no settings like that in runner studio, only going high or going low, am I blind or what haha any help would be greatly appreciated. Thanks.
-
- Super MS/Extra'er
- Posts: 1986
- Joined: Sat Jul 22, 2006 8:02 pm
- Location: Eureka, NV USA
- Contact:
Re: settings for edis in tuner studio
What firmware are we talking here?
Ken
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
-
- MS/Extra Newbie
- Posts: 3
- Joined: Sat May 16, 2015 6:39 pm
Re: settings for edis in tuner studio
Firmware, ms extra 3.3.3
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: settings for edis in tuner studio
EDIS wiring and configuration is covered in the manual.
http://www.msextra.com/doc/pdf/html/MS2 ... e-3.3.html
James
http://www.msextra.com/doc/pdf/html/MS2 ... e-3.3.html
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".