settings for edis in tuner studio

For discussion of Phil Tobin's Tuner Studio software (Only about the tuning software itself, not about how to tune or firmware features)

Moderator: LT401Vette

Post Reply
Rabbitracer43
MS/Extra Newbie
Posts: 3
Joined: Sat May 16, 2015 6:39 pm

settings for edis in tuner studio

Post by Rabbitracer43 »

Ok so I am running ed is4 with the modual, and I keep seeing g to set it to going high inverted, well there is no settings like that in runner studio, only going high or going low, am I blind or what haha any help would be greatly appreciated. Thanks.
Top
kjones6039
Super MS/Extra'er
Posts: 1986
Joined: Sat Jul 22, 2006 8:02 pm
Location: Eureka, NV USA
Contact:
Contact kjones6039

Re: settings for edis in tuner studio

Post by kjones6039 »

What firmware are we talking here?

:msq:
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
Top
Rabbitracer43
MS/Extra Newbie
Posts: 3
Joined: Sat May 16, 2015 6:39 pm

Re: settings for edis in tuner studio

Post by Rabbitracer43 »

Firmware, ms extra 3.3.3
Top
jsmcortina
Site Admin
Posts: 39611
Joined: Mon May 03, 2004 1:34 am
Location: Birmingham, UK
Contact:
Contact jsmcortina

Re: settings for edis in tuner studio

Post by jsmcortina »

EDIS wiring and configuration is covered in the manual.
http://www.msextra.com/doc/pdf/html/MS2 ... e-3.3.html

James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk

My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Top
Post Reply

Return to “Tuner Studio”