I've seen reference to this and have seen videos that demo it but don't see it in the menus. I'm either blind and missing it or maybe I don't have it because I still haven't bought the registered version. Can I get a pointer?
Thanks.
noob test mode question
Moderator: LT401Vette
-
- Super MS/Extra'er
- Posts: 1986
- Joined: Sat Jul 22, 2006 8:02 pm
- Location: Eureka, NV USA
- Contact:
Re: noob test mode question
Do you have a tab called CAN (bus Test Modes)? Just for the hell of it I removed the registration from my registered copy and Test Mode is still there. Just guessing here, but perhaps this is one of those MS (ini) version dependent things.
What version of MS are we looking at here?
Ken
What version of MS are we looking at here?
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
-
- Experienced MS/Extra'er
- Posts: 276
- Joined: Sat Mar 30, 2013 3:27 pm
- Location: MA, USA
Re: noob test mode question
Perhaps B&G firmware is loaded? Believe I've read that test mode is an msextra feature only
1990 Nissan 240sx / SOHC KA-T / DIYPNP
-
- Super MS/Extra'er
- Posts: 1986
- Joined: Sat Jul 22, 2006 8:02 pm
- Location: Eureka, NV USA
- Contact:
Re: noob test mode question
I'm thinking that you're right on top of it Lou!!BigLou240sx wrote:Perhaps B&G firmware is loaded? Believe I've read that test mode is an msextra feature only
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
MS2 v3 w/extra 3.4.2 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
TinyIOX from JBPerformance
Re: noob test mode question
Well sure enough. Now we know I'm just blind. Yes, it's int the CAN section.
Thanks a lot.
Thanks a lot.